Viking Built-In Convection Microwave Hood Instalační příručka stáhnout pdf

Mounting Space

This Convection Microwave Hood requires a mounting

space on a wall as shown in ﬁgure 1. It is designed to

be used with standard 12-inch wall cabinets.

For proper installation and servicing, a 2-inch space is

necessary between the top of the range backguard and

the bottom of the Convection Microwave Hood.

Wall Construction

This Convection Microwave Hood should be mounted

against and supported by a ﬂat vertical wall. The wall

must be ﬂat for proper installation. If the wall is not ﬂat,

use spacers to ﬁll in the gaps. Wall construction should

be a minimum of 2" x 4" wood studding and 3/8" or more

thick dry wall or plaster/lath. The mounting surfaces must

be capable of supporting a weight of 110 pounds—the

oven and contents—AND the weight of all items which

would normally be stored in the top cabinet above the

unit.

The unit should be attached to a minimum of one 2" x

4" wall stud or two 2" x 3" wall studs.

To ﬁnd the location of the studs, one of the following

methods may be used:

Use a stud ﬁnder, a magnetic device which locates the •

nails in the stud.

Use a hammer to tap lightly across the mounting •

surface to ﬁnd a solid sound. This will indicate stud

location.

The center of the stud can be located by probing the

wall with a small nail to ﬁnd the edges of the stud and

then placing a mark halfway between the edges. The

center of any adjacent studs will normally be 16" or 24"

to either side of this mark.

Viking Installation Guide

Convection Microwave Hood

111 Front Street

Greenwood, Mississippi 38930 USA

IMPORTANT–Please Read and Follow!

Please read all instructions thoroughly before installing the Convection Microwave Hood. Two people are •

recommended to install this product.

If a new electrical outlet is required, its installation should be completed by a qualiﬁed electrician before the •

Convection Microwave Hood is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2.

Backguard

At least 2"

15.5"

30"

12"

30" or more

from cooking

surface

66" or more

from ﬂoor

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Convection Microwave Hood

Mounting SpaceThis Convection Microwave Hood requires a mounting space on a wall as shown in ﬁgure 1. It is designed to be used with standard 12-inch

Strany 2 - Hood Exhaust Duct

E2When the hood is vented to the outside, a hood exhaust duct is required. All ductwork must be metal; absolutely do not use plastic duct. Check that

Strany 3 - Installation Hardware

E3Phillips Screwdriver •Electric Drill •½",• ⁵⁄₈" and ³⁄₃₂" Drill Bits1½" Wood Bit or Metal Hole Cutter •(if meta

Strany 4 - Ductless Operation

E4Ventilation System (Preparing Oven for Installation)This Convection Microwave Hood is designed for adaptation to three types of hood ventilati

Strany 5

E5Ventilation System (Preparing Oven for Installation)HORIZONTAL EXHAUST: Replace the fan cover bracket. Make sure the fan blades are visible t

Strany 6 - Oven Installation

E6Oven InstallationTHIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON WALL AND TOP CABINET TEMPLATES.M

Strany 7

E7Oven Installation(A)(B)(B)(C)(D)figurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefigurefi

Strany 8 - Checklist for Installation

E8Checklist for InstallationMake sure the unit has been installed according to all of •the Installation Instructions and the Wall and T

Další dokumenty pro Pece Viking Built-In Convection Microwave Hood

Zobrazit dokument Viking Built-In Convection Microwave Hood Uživatelský manuál

Viking Built-In Convection Microwave Hood Uživatelský manuál (15 stránky)

Komentáře k této Příručce

Žádné komentáře

Viking Built-In Convection Microwave Hood Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Pece Viking Built-In Convection Microwave Hood. Viking Built-In Convection Microwave Hood Installation guide Uživatelská příručka

Shrnutí obsahu

Další dokumenty pro Pece Viking Built-In Convection Microwave Hood

Komentáře k této Příručce

Související produkty a manuály pro Pece Viking Built-In Convection Microwave Hood